Just installed the ECU+ and it is able to log all vital info, but I am not able to see any info when I pull up OBD Tab. I had a CEL light come on yesterday and it didn't register and I was still able to clear the code via the old OBDII port w/ my old code scanner. Any ideas as to what I may be doing wrong? I was under the impression that I wouldn't be able to use the OBD port and do everything via ECU+.

 

I bet you forgot to set the jumper inside the silver box

 

I bought the box used, I will have to go through the manual to see if I can figure this out, can't you also just cut a wire if I remember correctly if you want to use your old OBD port?

 

Do not cut any cable. There is a jumper that you have to set inside the box. The box is easy to open. Read the manual about it. Shouldn't take you more than 5 min to have that done

 

Thanks

 

E-mail me for the procedure.

Tom

 

you have mail I sent it support@ecuplus.com is that your email?