i have just installed an intake today and i am having a cutting out problem now oh yeah and i have an ses light on also what could be causing this problem i got a 3psi after installing it so i am spiking 23psi now is that to much being that i am not tunned yet

 

Brandy, you don't have an ECU+. Why did you post this same thread again? Your problem is the intake. Put your stock intake back on and stop screwing around with your car.

 

because just needed to find out whats wrong with the car go read my new thread its under general

 

But this is the ECU+ forum. You can't just randomly spam the entire website just because you installed a bad intake without a tune.

 

yeah basically what is pissing me off is that it was working fine earlier when it wasnt even all clamped together the k&n filter wasnt clamped MAF sensor wasnt clamped and the induction crap wasnt even on but now that everything is on its being stupid i just think its got more air flow and a better suction other than that well besides that it might be over boosting but no clue

 

the problem is the intake fouls up your maf sensor's reading.. I'm assuming its the entire K&N Typhoon kit, which is known to cause problems on our car..

This is also not an appropriate forum for this question..