Can this be done?
Thread Starter
Evolving Member
iTrader: (17)
Joined: Oct 2004
Posts: 377
Likes: 0
From: San Antonio, TX
Can this be done?
I was wondering if there was a way to log knock using the available user input voltage in the Zeitronix ZT2?
I am able to see a/f, lamda, and boost right now. I didn't get the EGT sensor because I honestly didn't really think that it would be that helpful insofar as tuning goes.
If there was a way to monitor knock using the Zeitronix unit, it would preclude the use of a secondary logging software solution.
If anyone has any information I would greatly appreciate it.
Thanks,
Tony
I am able to see a/f, lamda, and boost right now. I didn't get the EGT sensor because I honestly didn't really think that it would be that helpful insofar as tuning goes.
If there was a way to monitor knock using the Zeitronix unit, it would preclude the use of a secondary logging software solution.
If anyone has any information I would greatly appreciate it.
Thanks,
Tony
Thread
Thread Starter
Forum
Replies
Last Post
TTP Engineering
Vendor Announcements
21
May 22, 2009 09:52 PM
krillin
ECU Flash
15
Feb 6, 2007 10:01 AM