I posted up a few weeks back and tried all of the sugestions but nothing helped.

So this is what Im getting when I try to read my ECU

[16:01:40.750] sending init sequence 1 (0001)
[16:01:43.968] sending init sequence 1 (0003)
[16:01:47.187] sending init sequence 1 (FFFF)
[16:01:50.390] sending init sequence 1 (F0F0)
[16:01:53.093] no response to any known code
[16:01:53.093] interface close
[16:02:09.796] Using interface OpenPort 1.3 Universal


And yes this is a common thread here (Ive searched a lot and have read EVERY ONE of them!)

This is the twist.

The car is an 2001 Eclipse Auto (is now a 5 speed) w/ and Evo 8 engine. I had a harness made by Boomslang made to convert to this ECU. I am able to log off the Evo Ecu, am even able to start it (the ECU came with the immobilizer deleted), but I cant seem to read it (I am however able to read the stock ECU). Ive tried all sorts of jumping of wires and cant seem to get it to work. Ive re-loaded all the software and still nothing.

I think the problem lies with the flash pin. Im not getting any voltage on my multi reader when I hook it up, but get some on my stock ECU. I tried jumping it to pin 62 on the Evo ECU but still nothing.

The battery has plenty of charge as well., and I am using the unlocker.