yes i know i should get rid of column 20-40 and have better res up top. i will sort that soon.
holds load rather well up to 6.5k or average ?
.

http://www.keepandshare.com/doc/2139...m-1-5-meg?da=y

3" Tbe,cat delete,ported 10.5,ebc,walbro,21psi,tune

 

You need to do a 100% throttle pull from 3000 to 7000 RPM's to see what is really going on. A second or two of WOT says nothing. Also log the basics to keep it simple; RPM's, Throttle, Timing, load, knock, and boost and afr if you can.

 

yes sorry it its wasn't a "pulls" log just a log of a drive out
deleted the 20-40 columns does this look right i.e i got the right values ported to the right columns ?
before



after

 

If it drives OK then stick with it. If not maybe go back and try deleting columns 0, 10, and 20 since they are all practically identical. Any load/rpm values in those area would reference column 30, which is also identical.

 

the scaling works seems smoother but might just be psychological.
struggling to hold 21psi all the way duty cycle upto 85% so far
conservative timing up top for good quality fuel?
3rd gear (six speed)
http://www.keepandshare.com/doc/2199...9-am-271k?da=y