As you can see from the pic, I have my EGT and BOOST guages installed in my dash. I cut out the holes and stuck them in there. I hate it, I just bought a greddy egt and boost guage and im gonna get the RRM cf dual pod to hold them. So I need to figure out what I am going to do with my dash. I am pissed I just cut holes in that **** cause now I don't know what im gonna do. Can I buy these pieces from the dealership parts department? Im hoping I can buy them in pieces and I do not have to buy the whole dash piece. Please respond with your thoughts/ideas/comments. Thanks.

 

Check your Mitsubishi dealer. They have everything for replacements.

 

people are always parting out their lancers.... just post it up in the classifieds and you'll probably be able to get it for pretty cheap

 

Yeah I would look for posts of Lancer owners parting out their cars. I just paid $191 to my dealership for the gray plastic piece that goes over the shift boot and the ashtray. Be careful who you buy from though, I just got out of a very tiring situation where I waited 2 1/2 months to get some parts I ordered from a 3rd party and, never actually got all the pieces that I wanted.

 

call up dealership they does have all the parts but it costly but it worth it!

 

bump

 

I went to the dealership yesterday...they tried to charge me 270 for the right side (it comes with like the full dash piece) and 140 for the left side. this is terrible, why cant i just buy the MAIN piece why do i have to buy the whole freakin assembly? anyone got any ideas? HELP!! thanks

 

Yup, ripoff...I went to my dealership w/ the same problem awhile back and looks like you got the same results I did.

I just wanted the silver strip that goes over middle vents, and the triangular piece on the left for the power mirrors. However, I couldn't just buy those two pieces by themselves. They said I needed to purchase the entire vent system. Like yeah, a lot of good that will do me!

My suggestions would be to try junkyards in your area or just wait until somebody crashes and posts a part-out on the forum. I got lucky and ran into that because none of the junkyards in my area had any Lancers. Good luck!

-Dan

 

You don't have a part number, do you?

 

Don't know who that's directed to, but if you're looking for the part #'s for the shift bezel and ash tray, I will dig through the trash for them and post them.

-Dan

 

get the CF replacements (the real ones, not overlays)... or just get the overlays and it will cover the holes

 

fake cf is lame. the part # is 73000. and i was wrong the price is $283.00 and I only need to buy 1 piece.