BrianWS

hello was wondering if some one could help me out... here is my situation was givin a long tube ingen cold air intake got my gts, all sounds good untill i relized i wasn't given the cvt cooler relocate bracket and hardware for it, i could fab one up but....yet again not given instructions or diagrams. if any one could possiblly post a link for a diagram or instructions that i have not found, or another forum post relation to this it would be greatly appreciated.
cheers : Brian

mci2727

iTrader: (12)

Are you sure this intake is made for your car?
I'm not finding a Injen brand intake made for a 2010 Lancer.

Or am I reading wrong?
What brand/modle intake do you have and what modle/sub modle is your car?

~Micah

BrianWS

hello micah ya so i have heard....it was off of a 2009 gts with the 2.4 and i have the 2010 2.4 more i look all i see is the cai for the 2.0L so i think the guy thought it was for the 2.4 and was using it on it when infact it was for the 2.0 Still working on it tho, i finally contacted injen and they said it should still perform and its identical to what they suggest for my application they just did not have enuff demand for making one for the 2.4 so im up in the air to still find the bracket but infact it is for the 2.0 L or i trade or sell it.

thanks for you time Micah

mci2727

iTrader: (12)

No problem.
Sorry I couldn't help.
Couldn't find a install sheet either, Injen's site needs a revemp!
Good luck with it.