If what I’ve read is correct, then the 02-03 Lancer ES trunks are virtually the same as the Evo 8/9, meaning I can put the Evo 8 wing on my ES. My question is, where do I drill the holes for the wing? I haven’t found a full tutorial but from a couple of videos I’ve seen it seems like there are pre-marked spots to drill the holes for the wing, since the trunk is the same just without those holes drilled for the wing.



If all that is true then the two holes should go
1) under the bump stop
2) where that indentation is

They seem to fit the model spacing wise, I’m just wondering if anyone has done this and can confirm that those are the correct spots for the holes.