For those of you who have opened your headlamp housing or just happen to know for any other reason...what is the circumference of the turn signal portion of the housing?

I'm debating doing custom angel eyes, but I'd like to do my rings before I open the lamps. I'm trying to avoid any other possible delays for the completion of my car, as it's been quite long enough already.

 

i dont know, but cencoastlancer(sp?) should. he was the one making halos a little bit ago.

 

maybe ask modelchris since if i'm not mistaken he already has some headlights taken apart?

 

Hobie - If you don't mind waiting a few days, I'm going to be helping someone black out their headlights probably this weekend. I'll get the measurements for you then if you want.

 

^ I got an 04 but yeah my headlights will be cracked open this friday hopefully

 

ive opened up my headlamps and some civic projector headlamps. the angle eyes are DAMNNNN near a perfect fitment as far as the circle goes on the blinker. I dont honestly know the actual measurements, but i think just about any halo ring will fit there.

 

I'm not sure about the circumference(sorry), but I'd say it has about a 4inch diameter.

 

The diameter is 3.5625 inches (or 9.04875 cm (or 3 9/16")) meaning that the circumference is 9.9678 inches (or 25.31823 cm). The diameter should be what you need. This is to the inside edge of the round part in the housing, the outside diameter of the clear lens.

 

What's that old school formula? C=3.14xR(2)

 

Dang, I was probably going to have the answer today *shakes fist*


j/k Actually, I'll double check it just so he can have two answers to confirm it; that is, I'll check it if Blue04ES isn't too wasted....

 

hee hee ^^ And yes.... C = pie are squared <----- I know it is spelled wrong

 

well since the other guy has had some problem with DIY angel eyes...maybe we should look into using the prefabbed ones that are available for the BMW and the like

check out

www.bimmerfreak.com
www.hidtech.com

 

isnt "pie R square" the area of a circle?

 

Yeah, the Circumference equals pie(3.14) x R-squared

 

Al you are right, but where is my ECLC decal