Ok, so here are the pix from my installs today. I cut a hole out of my Injen SRI heat shield to fit the stock ram air duct. In the summer this will help get cooler air when the engine gets hot. Also, I got my yellow tint done earlier. It was delayed from last week because it had to be custom ordered from Cali. I hope everyone likes.

 

If someone would like me to make a "HOW TO" for the intake shield thingy, I took pix during the steps of how to cut it, and all the measurements. Just let me know. If there is a high demand, I'll make a how-to article.

 

interesting idea, it should work. i do like how all of the custom heat sheild is all the same color.

 

Just 1 ? Why red instead of yellow? Nice though.

 

nifty!!!
not too ricy

 

I bought red and yellow paint.. but I finally decided to use red. I don't know why, but I could change it later if I need to. I though it would be too much yellow for the engine bay. I am also getting a K-style rally strut bar, and it comes red. I though I would have the intake system red to match.

 

with that in mind then i can see y u chose red over yellow

 

the yellow tint is definately different. I saw a lancer with a kaminari kit and red tint at the first evo vs wrx shootout at raceway park last summer. Colored tint isnt something I see much of.

 

Ya, I thought the yellow tint would make it stand out at a car show. I only have seen one other car in the whole state of michigan with yellow tint. So I'm just tryin to be a little different without going whacko.. lol.
edit: just trying to keep it clean lookin.

 

looks good. I like the custom intake heat shield. I like the color red on that for contrast, otherwise, it'd be too much yellow.

 

HOW????? Teach us!!!!!!!!!

 

yellow tint looks pretty good!

 

now THAT is original, props to you

 

Thanks for the comments, tomorrow I'll post a how to for the heat shield. I have nice detailed pictures to go along with it.

 

Cool! How did you do it?!