Its late, I'm getting off of work, and its a little bit chilly. I had parked under a light outside my job and I notice a little condensation on my hood. I had my car off for about 5 hours. No biggie you say...well I get closer to my car and notice the condensation is in the shape of the top part of this hood

I know that a little heat was probly still trapped under my hood from my drive, but I found it sooo neat that the condensation came up in that pattern. It made me think about my car wanting that hood and bumper.


On a side note to the people who have the Road Race or Accolade front bumper, does it extend lower than the OEM bumper and side skirts? I plan on getting the front end conversion but if it is going to extend down lower I think I might want to keep saving for the whole thing. Also for anyone who has the shorter rear bumper does that extend down lower than OEM?

 

weird..
um, it prolly extends down a little, but if you have the oem oz rear lip and sides it will look fine.

 

I have a Ken style kit my lancer; infact, a broken up rear Accolade Ken bumper and OEM are sitting behind me. The aftermarket is about 2-3 inches taller than OEM. I'd assume the same for the front and about 2 inches on the ss. Cool story on the hood thing...

 

your car is telling you it wants the evo hood!

 

rrm>>>> accolade

 

Actually on the factory hoods... there is a support on the back side of the hood that runs down the middle and 2 "pockets" with to the right and left of it... so the "design" you saw is very possible.

 

I've seen that pattern in condensation too..it does look kinda cool.

 

depends on which kit u get... im pretty sure all kits sit lower than oem. the only bumper i could think of that lines up with the OZ kit is the original Evo VII style from Import Trenz or RRM