Ok, I have the silver decal package on the car and i really cant stand out the front orange reflector cuts through the front wave on the front bumper. I might end up buyin a new bumper but for now, what should i do?? Paint it silver?? get a CF reflector? take it off and try to just put the decal over the hole? leave it?? I gotta do somehtin i think... anyway, any suggestions would be good.

 

paint the reflector to match

 

buy the clear ones from some company.. or u can get the clear ones from this lexus someone mentioned in this other thread.

 

just get a sheet of Vinyl sticker crap in silver, and just cover it that way, until you find another alternative

 

as far as i remeber you can have reflectors as long as they are white or orange in the front. i changed mine and have had no problems. of course i don't have a decal kit to attract that much attention either

 

either get the clear reflector from procarparts.com, or get a set of lexus RX300 running lights, they fit hole well, and you can have actual running lights where the reflector was

 

Get some rims, and smoke out the reflector!

 

i didnt know you can get that decal kit, where did you get it from if i may ask?

 

smoke it out, like was mentioned above. you can get that paint stuff to smoke out lenses. it'll be a greyish shade. or you can get a set of clears on ebay for $30. that'd be cool too.

 

Black it out with paint, if your lazy just cut some vinyl to it , or spen 10 bucks and order teh clear reflectors.

 

wow those are some nice decals. but yea, just get the clear reflectors

 

Yeaah... thanks for all the comments... i never thought of gettin clears... now that i try to picture that.. that might be hot.

i have a bunch of decal cuz i had MI send me a roll so i can replace teh front bumper peice once i get the front kit.. and yea, i'm buyin the gunmetal vx8s in june w/ skunks 2s. so if thats the case, would CF or smoked out be better than clear or silver decal covering?

I put the decals on last summer. I called up MI and asked if they could hook me up w/ it.. cost me an arm and a leg cuz they didn't want to print it again but they did. i guess its cuz its so complicated.. but anyway.. i think that answered everyone.. thanks for all the hits.. ok, so smoked out, since i'm going gunmetals?

 

either smoked out or clear would look great

 

u can get clear ones off procarparts