When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Looks awesome! How much fabrication did it take? I was thinking about going the same route actually.
hmm well the ebay projector housing is too small to fit the tsx projectors.. so i had to cut the metal bracket and shave the projectors a little bit to fit.. wasnt that hard ` go for it!
Originally Posted by austenm
How do you finish them? do you bake them after you install the projectors?
yeah just rebake the back side then put it back together. i think youre supose to use clamps, gotta go buy some
Originally Posted by SLVROZ_03
Hope you left those super, JDM twistie ties in the housing! LOL
super JDM. of course thats all im gona use to keep them in place jdm like that
Originally Posted by ambystom01
Looks good, that's how everyone who wants HIDs should do it.
yeah im tired of being blinded. dont wana blind others with PNP kits
jdm like that
