hey everyone. i just got an rmr type 2 lip but it didnt come with any drilled wholes on it just the double sided tape. jsut wondering if the piece would hold on to your cars without drilling any holes or should i drill some whole thanks everyone

 

hey i have an rrm type II lip too

the way im gonna do it is with the double sided tape and im gonna bolt it on at the part that goes inside the wheel well on each side

 

i have the type1 lip and i bolted both sides and then double taped it.. it didnt hold up long and then i used epoxy and everything i could find in my garage lol
and the lip keeps sliding off the bumper towards the center of the bumper so im bringing it to a bodyshop to put it on the right way lol im too lazy to try anything else

 

the type 2 lip covers the middle piece of the lower bumper tho and it kinda fits in snug so it shouldnt slide off

where as with the type 1 you have to cut that middle piece off

 

right i forgot lol you guys are lucky
since i dont have that middle piece the lip slides down
heavy duty double sided tape should do the trick

 

haha howd you get the courage to cut you bumper slvroz?

 

I'm sure there's some sort of adhesive that you could use to attach it.

 

yeah i was thinking of doing what shut out was gonna do. alryte

 

hahaha i have no idea
i didnt even think i kinda just did it