ok i have and 02 es A/T and i am looking to turbo my car but i know that i need to beef up my tranny. so i found level10 performance trans. and am going to get their bulletproof torque converter and their valve body. the question i have is how do i remove them to send them in. Also if there is anything else i need to do to prepare for the turbo i would love to know thanks.

 

You will need to remove your transmission to gain access to your torque converter. It is located between the engine and transmission, inside the bellhousing. Your valve body can be accessed by removing the valve body cover on the front of the transmission. See the FSM diagram below.

 

ok cool thanks man. anything else i should upgrade before i turbo?

 

Everything else needed can be installed when the turbo is installed - fuel pump, injectors, colder range plugs, etc.

 

ok cool sounds good thanks.

 

Take it over to Jms Racing in San Antonio

 

really what do they have?