Do you know what year they revised the gears? Curious if my 06 has em already.

 

It was my understanding that no evo's would have got them from the factory. It would have most likely been changed by someone else is you do.

If you have no issue with a hard turning knob, i wouldn't worry about it.

 

Thanks so much for making this video! It's the next project that I'm going to tackle and I wanted as much info as possible before I start tearing into my dash.

I still don't quite get the cable attachment point on the control unit, but I'll poke around with a flat head and see what I can figure out.

You mentioned that if the heater knob was broken that we may need more than just these parts. Do you just mean that we would also need a new knob? They seem pretty hard to come by and I could use to replace all three.

Thanks for the info and the quality video!

 

I mean, if the shaft the knob goes onto is broken, you need more parts than this.

 

Ok, gotcha. Just wanted to make sure I wasn't missing anything else. Looks like the shaft is fine.

Thanks!

 

If you still have these, I'll take them.

 

Yes, Paypal celicamero@hotmail.com $55 and i will send:
(1) 7801A110 - revised gears
(1) MR979515 - wire

-Paul

 

Done

 

Received. I will message you to confirm shipping address.

 

Broke the white plastic stud where the knob connects to. I want to purchase the kit but also the part to replace the plastic stud.

 

Do you have anymore in stock?

 

Yup, like 5 sets. paypal celicamero@hotmail.com, then PM me here to confirm your shipping address.

 

Its possible to fix... but your probably better off buying the whole control unit.
Not mine, just a link for reference. https://www.ebay.com/itm/2002-2006-M...7bdc%7Ciid%3A1

 

4 sets left!