Max torque for a mr
Thread Starter
Newbie
Joined: Sep 2011
Posts: 4
Likes: 0
From: québec
Max torque for a mr
Fisrt.. i speak french... so i know they will have many mistake (sorry)
I read many post on mr tansmition put no one can tell... and it was in 2008
Now in 2011...anyone can tell my if a put 350 whp 330 torque.... on mr tanny... can take it?
Second question...
if a instal
cat back,
air intake,
boost controler (24 psi)
z-chip
Any thing i need more for the mr tranny?
Thx
I read many post on mr tansmition put no one can tell... and it was in 2008
Now in 2011...anyone can tell my if a put 350 whp 330 torque.... on mr tanny... can take it?
Second question...
if a instal
cat back,
air intake,
boost controler (24 psi)
z-chip
Any thing i need more for the mr tranny?
Thx
Last edited by gpremier01; Sep 26, 2011 at 11:52 AM.
That is incorrect.
With proper tuning it has been shown to break 400 WTQ. Beyond that clutches will need to upgraded, and then a re-tune again to adjust for this further increase in torque.
With proper tuning it has been shown to break 400 WTQ. Beyond that clutches will need to upgraded, and then a re-tune again to adjust for this further increase in torque.
The Z-Chip is very bad for the car. Many many times people have damaged their car's from the Z-Chip. You should get either a pro-tune (go to a tuner in your country) or do an email tune (contact one of the big vendors on here and ask them fir help on email tuning).
BTW= By The Way
BTW= By The Way
Thread
Thread Starter
Forum
Replies
Last Post
