Just to keep in Mind In can host a few hundred cars in Canton, Ma. at the old Blue Hills Lincoln Mercury Dealer. It's about 1 miles off of 93/95 on Rt 138.

If anyone wants to set something up..

 

Wait is that the dealer next to 99? I used to work down the street from there on Dan Road..

 

Just keep it low and you should be fine. I have a catless setup but when I'm just coasting you can barely tell..

 

Thanks for your information.

Any issue with state inspection?

 

hey dudes, is this where all the mass folk' chit chat ?

 

Does anyone know anyone around here that would be able to do a compression and boost leak test on my car? I just wanna make sure everything is right before I go to Ivey.

 

that is quite the drive for such little mods.

 

Yea it's gonna be about a 500 mile round trip but its ok. I barely drive the car so I might as well take it out for a lil road trip. I'm hoping to get an early morning tune so I don't have to be stuck in traffic.

 

What are you gunna do if the compression is f*cked? I wouldn't bother personally... there's no way its bad. Boost leak test would be smart to do tho.

 

Compression test is never a bad thing to do. I did it yesterday. I would highly consider it especially if you are going to long haul it for a tune.

 

I just wanna make sure everything is fine before I call for an appointment and waste my time and money. I especially wanna do a boost leak test because I removed my turbo and I wanna make sure its not leaking from the gasket and that none of my IC pipes are leaking. It's holding 17 PSI with no problems but I just wanna make sure. I've never done a boost leak test nor do I have the equipment to do so. That's why I'm hoping someone local would be able to help me out.

 

Josh,

We can talk about boost leak and compression testing. I might be able to help next week. We should also talk about your trip to Ivey...with regards to what I mentioned the other night when you picked up the helmet.

PM me next week. We can put something together then.

-D

 

Dave, feel free to ***** out my design for the tester. It only cost me $7 to make. It is not a bad little device to have when owning a turbo car.

 

thats a hell of a drive to ivey's shop especially for such a lightly modified car. I find it hard to believe theres nobody competent in MA,

 

Who said there is nobody competent?