**New Date** EnglishRacing North End Dyno Day 1/25/13
#1
Former Sponsor
Thread Starter
**New Date** EnglishRacing North End Dyno Day 1/25/14
Again, we apologize for the previous cancellation and any inconveniences we might of caused, but we were able to set another date with Drift Office to accommodate you guys.
----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Read the entire first post, this will save everyone from confusion.
To Get on the list please post in this thread that you would like to be added to the list, in your post please include your real name. We are looking for 10 to 14 cars. If the list is full, you may get on the Wait List as people tend to cancel, which will leave room open for you. If that's the case, this list will be updated and you will receive a PM that you have been placed on the list.
You may also show up on the date and if all goes smooth and everyone gets done faster than expected, there could be room for you on the wait list.
When: Saturday, January 25th
Where: Drift office @ Auburn
1535 Auburn way North
Auburn WA, 98002
Dyno Jet AWD
TUNERS: Aaron (JohnBradley)
Lucas English
Time: We'll start at 10:30 AM
Please note that pricing has changed for this dyno day. The prices we had been using were based off of 3 pulls. Everyone at the dyno day can attest to the fact that almost no car was limited to three pulls. The pricing structure is being changed for this reason.
Going from a stock turbo (8 or 9) to a bigger turbo, will put you into the new tune category. If the car has changed ownership but was previously tuned by us it is considered a new tune only, none of the other changes apply.
Dyno Price (add this to the Tune):
Dyno price for new tunes and retunes will be $100
Tune price:
Retune – 100
full tune- 200
So to figure out your total you add the dyno price to the tune price.
A new tune would be 200+100= 300
A retune would be 100+100=200
Additional charges (doesnt include dyno time, see above for dyno charge)
Add SD (tune only, sensor extra) + $100
Add meth - +$50 (250)
Add larger injectors- +$100 (300)
Add both- +150 (350)
E85- 300
E85 and limp home gas map- 450
AEM- 750
DSMlink- 200
Evo X MR SST tune- 100
Spark plug covers and undertrays must be off before you get on the dyno! There have been alot of people the last 2 dyno days that have not been listening to this warning. If your undertray is not off there will be a nonnegotiable $20 fee to remove it and another $20 to reinstall it.
YOU MUST HAVE YOUR SPARKPLUG COVER AND UNDERTRAY OFF
SATURDAY January 25th:
1. jwalleg - SD Tune
2. projectgarage (Dan) - Retune
3. freshkid (Aly) - ReTune on SD
4. ILikeApples (Davis) - Retune
5. DOzzyman (David) - Retune
6. Max - Retune
7. Canadian-Ix (Rob) - ReTune on SD
8. Rdjohnson12 (Ron) - New Tune
9. KingJames206 (James) - New Tune
10. WFO-TSi (Scott) - New Tune
11. Mark Bryant - ReTune
12. Flattracker33 (Tyler) - New Tune
13. f-dub (Fred) - ReTune
14. JohnnyTSi (John) - ReTune
Waiting list -
1. Derek - EvoX First Time
2.
3.
4.
5.
Last edited by Az_636; Jan 22, 2014 at 08:41 AM.
#4
Put me down.
Retune but with added parts
08 Evo x MR
4" FMIC
Cobb turbo inlet
Cosworth panel filter
Grimmspeed 3 port boost solenoid
Intercooler piping
Synapse diverter valve
Fujitsubo catback exhaust
Invidia downpipe/testpipe
English tune
English SST tune
Adding:
AEM water meth setup
Open O2 dump
What do you guys want/recommend as far the water and methanol mix?
Thank you,
Dan Scarsorie
Retune but with added parts
08 Evo x MR
4" FMIC
Cobb turbo inlet
Cosworth panel filter
Grimmspeed 3 port boost solenoid
Intercooler piping
Synapse diverter valve
Fujitsubo catback exhaust
Invidia downpipe/testpipe
English tune
English SST tune
Adding:
AEM water meth setup
Open O2 dump
What do you guys want/recommend as far the water and methanol mix?
Thank you,
Dan Scarsorie
Trending Topics
#9
Former Sponsor
Thread Starter
#14
Former Sponsor
Thread Starter
#15
Evolved Member
iTrader: (55)
Join Date: Aug 2006
Location: Monroe - WA
Posts: 3,282
Likes: 0
Received 0 Likes
on
0 Posts
nice! I'll do everything in my power to make this one! I think I'm ready to make the jump to ethanol...screw this local gas, and waiting for ethanol. For that I'll likely head down to the shop though, sometime this spring.
BTW - for anyone that needs methanol, I have the better part of 50 gallons in the garage. I'll damn near give it away, just let me know.
BTW - for anyone that needs methanol, I have the better part of 50 gallons in the garage. I'll damn near give it away, just let me know.