Well, thanks to a ****ty FX400 clutch I have to get another new clutch and possible rework on my Shep built tranny. So in order to fund this project again, I need to let my turbo go. I bought this turbo for my next build, and it has never been installed on a car. The most I have done is pulled it out of the box and drooled over the sight of it.
This ef2.5 is set to use the stock inlet housing, and has the exhaust side ported. No compressor housing porting or thermal coating. It also comes with an optional 23lb wastgate spring. I ordered it like that because I am heavy into autocross and wanted quick down low spool.

I am asking $1700 shipped, from MAP, it is 1735.99 and at least a 2wk wait.
I am even willing to work with MAP to get the warranty paperwork switched over if they will allow it.

So bottom line...Ef2.5 using stock inlet elbow, and ported exhaust and turbosmart waste gate, with optional 23lb spring for $1700 shipped.

 

Bumpty Bump

 

Sent a PM.

 

Bump - that sucks about your clutch/trans.

 

Thanks man...not looking forward to that clutch bill...boo!