FS: 65mm Throttle Body & Gasket
Bump for WOT. I just installed the throttle body and it is a beautifully done piece. I also bored out the intake many to port match. It feels a lot torquier. And with my big turbo, it helps spool up slightly.
Thread Starter
Former Sponsor
iTrader: (161)
Joined: Jun 2003
Posts: 3,043
Likes: 13
From: San Elijo Hills, Ca.
Originally Posted by o.e.boost
im up north but do you portmatch the intake mani too...i was thinking about coming down for one day(live in the central valley) and getting the exchange/port matched mani done...possible?
Kim-Thanks for your input
Thread Starter
Former Sponsor
iTrader: (161)
Joined: Jun 2003
Posts: 3,043
Likes: 13
From: San Elijo Hills, Ca.
still available.
The next tb i get, i plan on conducting a dyno compare, same day ~30 minutes apart, same car, same mbc setting, etc.
A awd dyno shop recently opened up ~5 miles from my house & I plan on conducting my own 60mm vs 65mm dyno compare
The next tb i get, i plan on conducting a dyno compare, same day ~30 minutes apart, same car, same mbc setting, etc.
A awd dyno shop recently opened up ~5 miles from my house & I plan on conducting my own 60mm vs 65mm dyno compare
Originally Posted by WOT
still available.
The next tb i get, i plan on conducting a dyno compare, same day ~30 minutes apart, same car, same mbc setting, etc.
A awd dyno shop recently opened up ~5 miles from my house & I plan on conducting my own 60mm vs 65mm dyno compare
The next tb i get, i plan on conducting a dyno compare, same day ~30 minutes apart, same car, same mbc setting, etc.
A awd dyno shop recently opened up ~5 miles from my house & I plan on conducting my own 60mm vs 65mm dyno compare
