Revolver cams, ran them for a while, but the car is going back to stock. These cams made tons of midrange torque/power and were a blast to drive on the street. Plus they had the meanest idle I've ever heard from a 4 cylinder in my life. Well, next to the RWD talon with it's 5" stright pipe. $450 takes them. They're out of the car, boxed, and ready to ship.

 

Couple bites, but no sale yet. These are still available.

 

can you use stock valve train?

 

It's not recomended.

 

I have a question.....

Do these need a special bolt for the camshaft position sensor? I ask because I have a set and have not put them in yet because I was told they need a special bolt.

FYI...you MUST use different springs. The stock ones will bind because of the high lift.

 

Yes, it is a different bolt. M8x1.25, of an appropriate length. The stock bolt is M10 or 12 with a 12mm head, very unusual piece.

 

Bump for a great set of cams.

These are great if you are an AutoX racer or enjoy doing back road twisty driving. The midrange is insane ! !

Thanks for the info. Good luck with the sale.

 

I agree, the midrange, and even the low end, is ridiculous. The car was 100 times more fun to drive on these cams.

 

I've listed these on NABR, where I don't have to deal with low balling ******s with no money, for 300 bucks. I'll do 400 shipped on this forum if you don't **** me off. If you don't like my lack of feedback or limited transactions on this site, or don't trust me for any other reason, don't waste my time, go lowball someone that you do trust.

Thanks in advance.

 

pmed

 

Sold.