Mark this thread as Unsold
2.4 stroker fully assembled longblock
2.4 stroker fully assembled longblock
Engine Setup: Looking to get WAS $5000 --- NOW -$4800 plus paypal fees and shipping!!!
- 2.4 stroker longblock
- OEM crankshaft
- ARP Headstuds
- Wiseco HD pistons w/ upgraded wrist pin
- Manley H-Beam Connecting Rods w/ ARP 2000 rod bolts
- OEM 4G63 Mitsubishi Water Pump
- OEM front case w/ OEM oil pump and gears
- OEM 4G64 overbore Multi-Layered-Steel Head-gasket
- OEM Mitsubishi timing belt, tensioner, and pulleys
- Balance shaft eliminator kit
- Kelford 272 cams
- Manley single springs and retainers
- Stainless steel o-ringed head
- Fidanza adjustable cam gears
- Zaklee Corp Clear Cam Gear Cover
- OEM Mitsubishi valve stem seals, valves, lifters, rockers
Motor has 450 miles on it. The car is currently being broke in and once it reaches 1000 miles will be getting a full tune. All gaskets, pulleys, timing components, etc have been replaced using oem Mitsubishi parts.
The head has 450 miles on it since the refresh. A fresh valve job was performed on the head using brand new oem valve stem seals. The head was decked, O-ringed, pressure tested, and hot tanked.
Looking to sell as a fully assembled longblock, however if I have a buyer for the head and the bottom end I will separate.
Head - $2100 obo plus shipping/paypal fees
Bottom end - $2900 obo plus shipping/paypal fees
- 2.4 stroker longblock
- OEM crankshaft
- ARP Headstuds
- Wiseco HD pistons w/ upgraded wrist pin
- Manley H-Beam Connecting Rods w/ ARP 2000 rod bolts
- OEM 4G63 Mitsubishi Water Pump
- OEM front case w/ OEM oil pump and gears
- OEM 4G64 overbore Multi-Layered-Steel Head-gasket
- OEM Mitsubishi timing belt, tensioner, and pulleys
- Balance shaft eliminator kit
- Kelford 272 cams
- Manley single springs and retainers
- Stainless steel o-ringed head
- Fidanza adjustable cam gears
- Zaklee Corp Clear Cam Gear Cover
- OEM Mitsubishi valve stem seals, valves, lifters, rockers
Motor has 450 miles on it. The car is currently being broke in and once it reaches 1000 miles will be getting a full tune. All gaskets, pulleys, timing components, etc have been replaced using oem Mitsubishi parts.
The head has 450 miles on it since the refresh. A fresh valve job was performed on the head using brand new oem valve stem seals. The head was decked, O-ringed, pressure tested, and hot tanked.
Looking to sell as a fully assembled longblock, however if I have a buyer for the head and the bottom end I will separate.
Head - $2100 obo plus shipping/paypal fees
Bottom end - $2900 obo plus shipping/paypal fees
Last edited by CrAwLiN3vO; Aug 31, 2011 at 12:57 AM.
Trending Topics
Bump somebody make me a legitimate offer on this and its yours! Shipping is going to cost $500 to anywhere in the continental 48. WILL NOT SHIP OUT OF COUNTRY. WILL NOT SHIP TO HAWAII OR ALASKA. US 48 only!
