Mark this thread as Sold
map stage 2 2.4liter longblock
Apr 3, 2012, 07:22 PM
#1
Evolving Member
Thread Starter
iTrader: (12)
Join Date: Sep 2009
Location: iowa
Posts: 123
Likes: 0
Received 0 Likes
on
0 Posts
map stage 2 2.4liter longblock
$3500
Map Stage 2 2.4 long block
-Ultimate duty Rods
-acl race bearings
-acl mains
-acl thrustd
-wiesco 4g64 with 4g63 head (22mm pin) 1400H.D. pistons
-mitsu balance shaft delete
-oem oil pump/ front case
-H11 head studs
- new oem timing belt and tensioner
-power enterprise heavy metal head gasket
--line honed etc etc, all assembled by map.
-Map stage 3 head prep
-si intake valves
-si exhaust valves
-fererra valve seals intake and exhaust
-fererra valve guides
-gsc S2 cams (274 274s)
-new oem water pump
-water pump adapter and gasket
-cam gears... brand escapes me.
-degreed to block
there is 7 hours of use on the motor
ate all mains.. crank is ****.
Map Stage 2 2.4 long block
-Ultimate duty Rods
-acl race bearings
-acl mains
-acl thrustd
-wiesco 4g64 with 4g63 head (22mm pin) 1400H.D. pistons
-mitsu balance shaft delete
-oem oil pump/ front case
-H11 head studs
- new oem timing belt and tensioner
-power enterprise heavy metal head gasket
--line honed etc etc, all assembled by map.
-Map stage 3 head prep
-si intake valves
-si exhaust valves
-fererra valve seals intake and exhaust
-fererra valve guides
-gsc S2 cams (274 274s)
-new oem water pump
-water pump adapter and gasket
-cam gears... brand escapes me.
-degreed to block
there is 7 hours of use on the motor
ate all mains.. crank is ****.
Last edited by toxic-evo; May 7, 2012 at 05:20 PM.
Apr 6, 2012, 11:38 PM
#7
Evolving Member
iTrader: (1)
Join Date: Jun 2007
Location: Melbourne, Australia
Posts: 281
Likes: 0
Received 0 Likes
on
0 Posts
have you spoken to map about this?? was it assembled by them or you. cause push/pull does not require different thrust washers. people do it on stock motors all the time. sorry just doesn't sound right
