Mark this thread as Unsold
FT NY: FP Black (Whole setup for t3 or downsize)
Thread Starter
Evolving Member
iTrader: (32)
Joined: Jun 2007
Posts: 119
Likes: 0
From: Long Island, NY
FT NY: FP Black (Whole setup for t3 or HTA green/red/BBK)
I amm looking to change up my setup.
WILL TRADE MY BLACK AND MY O2 DUMP FOR A SMALLER TURBO + CASH or entire setup for T3( i already have a seperate o2 housing)
Trades excepted:
gtx 30r kit
other quality t3 kit
HTA green/red
My setup:
FP Black JB with receipt for rebuild and documentation of tune and mileage. (under 500)
FP inlet and feed line and KNN Filter
MUSE o2 Dump
Buschur DP
ETS LICP
WILL TRADE MY BLACK AND MY O2 DUMP FOR A SMALLER TURBO + CASH or entire setup for T3( i already have a seperate o2 housing)
Trades excepted:
gtx 30r kit
other quality t3 kit
HTA green/red
My setup:
FP Black JB with receipt for rebuild and documentation of tune and mileage. (under 500)
FP inlet and feed line and KNN Filter
MUSE o2 Dump
Buschur DP
ETS LICP
Last edited by Paulito; May 23, 2013 at 07:13 PM.
Trending Topics
I have a turbo trix T3 manifold, just ceramic coated semi gloss black, Tial 44mm wastegate, and a journal bearing PTE5031 with only 9k miles on it. No shaft play, will include all oil lines, and the 5 bolt downpipe that bolts up to your stock downpipe. I was actually just about to post my setup to trade for a Stock frame turbo setup. I am located in south jersey but I can meet up with you if you are intersted.
I also have a 3 inch Intake Pipe I used with a halfcore rad that was mounted on the passenger side which sat the piping right behind the grill I ran with a velocity stack with a filter.
