Mark this thread as Unsold
Full 3" AMS TBE v2
I'm looking to replace my exhaust with a new piece so I just want to see if there's any interest for my full AMS TBE. It's made for the USDM bumper but it fits the JDM rear if you stiffen the rubber hangers or trim the bumper. There is one small ding in the muffler that I didn't even know about until I removed the axle back to polish the muffler. There's also o2 bungs located on the cat back as well as the test pipe. It will clear the lower tie bars as long as you use spacers. I'm looking for $400 picked up or $450 shipped. Located in Tyngsboro, MA.
More pictures:
More pictures:
Last edited by 19DB794; May 12, 2014 at 07:57 AM.


