Mark this thread as Unsold
FS[West]: CBRD BBK Full JB AKA BPT 1.0XT
#1
CBRD BBK Full JB AKA BPT 1.0XT
Just rebuilt. Zero miles. Just rebuilt. Zero miles. Just rebuilt. Zero miles.
Time to let this go. I just built a stroker and this turbo would have run out of breath if I chose to run it. Previously had less than 25k miles. I opted for a rebuild for new owner piece of mind. Every bearing, seal, and o-ring replaced. Both compressor and turbine wheels re-balanced. Turbine inlet was already ported when I got it then I had it coated by polydyn a while back.This is the perfect pump gas turbo for a 2.0L with a little compromise in spool. E-85 just wakes it up, and is capable of 460- 500whp VD consistently.
Will come with what you see, new oil drain gasket, crush washers, j-pipe gasket. FAP cover Anti Surge @84mm, & 18 psi wastegate.
Does NOT come with lines, fasteners, j-pipe, or other gaskets for manifold or O2 housing.
Finishing up the build so will only entertain the following trades, cash on my end as appropriate:
Ported or CNC IX head,
Built 5 Speed Trans,
Built T case,
T3/ T4 A/c compatible hotparts kit,
AEM Infinity,
possibly other turbos. (I already have a BB Xona FP Black)
Partial trades, cash on your end:
Double pumper + $900.
Asking $1450 OBO shipped. Buyer responsible for PP fees or other payment arrangements. Will have this on here for about 10 days and if doesn't sell it will be off to fleabay. Check my other listings. Thanks for looking.
Time to let this go. I just built a stroker and this turbo would have run out of breath if I chose to run it. Previously had less than 25k miles. I opted for a rebuild for new owner piece of mind. Every bearing, seal, and o-ring replaced. Both compressor and turbine wheels re-balanced. Turbine inlet was already ported when I got it then I had it coated by polydyn a while back.This is the perfect pump gas turbo for a 2.0L with a little compromise in spool. E-85 just wakes it up, and is capable of 460- 500whp VD consistently.
Will come with what you see, new oil drain gasket, crush washers, j-pipe gasket. FAP cover Anti Surge @84mm, & 18 psi wastegate.
Does NOT come with lines, fasteners, j-pipe, or other gaskets for manifold or O2 housing.
Finishing up the build so will only entertain the following trades, cash on my end as appropriate:
Ported or CNC IX head,
Built 5 Speed Trans,
Built T case,
T3/ T4 A/c compatible hotparts kit,
AEM Infinity,
possibly other turbos. (I already have a BB Xona FP Black)
Partial trades, cash on your end:
Double pumper + $900.
Asking $1450 OBO shipped. Buyer responsible for PP fees or other payment arrangements. Will have this on here for about 10 days and if doesn't sell it will be off to fleabay. Check my other listings. Thanks for looking.
Last edited by slipperychicken; May 9, 2016 at 07:19 PM. Reason: Added stuff, updated trade list.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Anarchy99
For Sale/WTB - Engine / Drivetrain / Power
9
Nov 28, 2012 12:11 PM