Everyone can dyno that comes, EXCEPT if you have anything from "Vishnu" on your car. Yes, this means you tagger. Dont just show up thinking you are dynoing. Eveyone else is welcome to dyno.

Just kidding. I guess they will let anyone dyno, as long as it doesn't get to late.

I am going 3rd or 4th on the Dyno.

BTW, lowest dynoing Evo buys Dinner.... And beer!! So bring alot of money tagger!!!

Brian

 

haha what kinda numbers are you guys looking at?

 

264 whp last time on a Mustang dyno for me. I guess I better bring some money too, huh. Everybody coming with the Evo's are running 16G turbos. Some have 10.5 housings... Maybe an Alcohol injection car, if he finishes the install.

Brian

 

i dont have 10.5 or anything...i layed 291whp on the heartbreaker (dynodynamics), have been told should be around 340 on dynojet. Thats what im wanting to see, so I can compare numbers.

 

If thats the case, then maybe the high Evo dyno man will buy dinner and the beer!!! Sound like a good idea???

Brian

 

works for me cause it aint gonna be me. No 10.5 housing. (i dont see spending the money for the housing when i plan to upgrade later.)

 

if you were on a DD dyno then you must be a vishnu guy eh?? :P

dangit i may have to get up early and install my cams tomorrow morning just so i dont dyno with the lowest numbers ahaha

since ill probably be the only car there thats not flashed i should get free dyno time!!

btw brian its about time you ordered that damn c/f rear bumper shield

 

Actually im not using any Vishnu Stage. Just decided to go with their management.

 

good enough for me...im in the same boat and am not really following their stage path...but i do run the xede

 

My Carbon Fiber bumper shield will be here Monday via UPS. I need it pretty bad with the Greddy Titanium exhaust. The dyno we dynoed at in Mooresville, the bone stock Evo that we had there made 180, 182 and 184 awhp. It reads very low. I have added a few parts since that dyno, we will see if I made any forward progress.

New mods since last dyno are:

SSAutochrome manifold
10.5 housing with titanium turbine wheel
Greddy Upper IC pipe
HKS DLI2
Custom dynoflash

We will see how it does.

Brian

 

how do you like the manifold?

 

hmm yea i was thinking about that manifold too

i also plan to add the 10.5 housing this summer when the buscher 20g wheel comes out whoopee

 

The manifold and 10.5 housing were switched at the same time, so I can't tell you what each one did. I like the combination with both of them on there. It seems to be holding up well so far. It seemed to pull harder up top, with the combo on there. It was like adding cams again... At least thats what my butt dyno told me.

Brian

 

i plan on doing an ATP 3037S kit in the future, I want a manifold that will be able to support the weight of it.

 

brian how fast can you install cams if you had my help?? i doubt we could do it there on sat but maybe its a possibility...before and after dyno charts w/ and w/o 272 cams

i was planning on installing them next weekend