Originally Posted by dambikeracer

any pics of it mounted on the car? any dyno sheets comparing it vs anything else?

Originally Posted by kanyonkid

Ok so i installed everything. I had to remove this bracket to the ac pump in order for the mani to fit. Also had to remove my URAD to put it on because its a hard pipe. There's about a 1/2 inch from the runner and the URAD. I gotta wait a lil more on the pix. But damn does it look good on the car. After a quick heat cycle of the mani it turned bright gold!!! it was sooo sexy. Then after tuning its a dark bronze. My HTA green hits full spool at 3800rpms selftuned... Can't wait til next week. Pix to come!

Originally Posted by dambikeracer

So are you going to have to take the AC off to make the manifold work?

Originally Posted by RockmanX

there is a thread already where somebody ran results with a unported manifold