I know this question was asked a couple days back but no one has answered it yet. so please

1. Cost of 10.5 housing
2. Cost of install

How much power will this alone add? Please specify Lowend, midrange and Highrange

thanks

 

http://linux.forcedperformance.net/m...ode=Lancer_EVO

Install is fairly easy - you can do yourself.

 

thanks

 

Has Vishnu or anyone else done a test with and without the 10.5 housing to support a HP increase and better spool up? I'm not talking about putting in other mods along with the housing...thanks

 

It spools up about 200 rpm slower than stock due to the larger nozzle area. I have a Stage 1+ setup with the 10.5 hotside and I put down 307whp 93oct and 324whp ~110oct on a DynoDynamics Dyno.

You might get 10-15whp out of it with the right mods.

 

Housing will gain approx 15 whp (Dyno Dynamics) over a simular stage 1+ with the 9.8cm unit..
Better spool up is obtained with the TME 16g with the titanium internals that is a full 33% lighter than the stock inconel cartridge

 

Andrew, hows that site update coming?

 

Slowly.....sorry everyone, won't be for a few days..

 

Anyone from Vishnu know how much it would cost to install the forcedperformance 6.5 TME turbo w/10.5? I'm assuming that would probably need a custom tune for it to be truly beneficial right?