So I bought the Aquamist 2d setup with the DDS3 gauge some time ago. I never installed them and now they are up for sale. But what I did do was fabb up this bracket to hold all the 2d bits and parts. It's made from standard 3/8" thick Al sheet metal. After about a week of jig-sawing and tinkering, it finally came together.

This bracket is pretty much a direct copy of a bracket Aquamist made a couple of years back. I'm not sure if it was ever for public sale but I managed to find a pic of it somewhere. The only changes I made to it included the addition of the flat, edged piece (so it could be custom mounted). And I think that mine is overall smaller than the original Aquamist bracket.

I originally planned to place this where the stock intake box mounts to (that is, if you removed the stock intake, removed the bracket, in front of the battery tray and tranny). The flat piece of metal with the edged cutout was suppose to be bolted (didn't get around to drilling the holes) to the frame with the entire unit hanging off to the side in front of the tranny. Hope that made sense. Of course, not for use with the stock intake box (I was running a filter on a tube for my intake so I had plenty of room).

Just thought I'd share.

Oh, and if you want, more picture can be seen here, on page 2.