***Official NV Chat Thread***
sup panda...
a few of the x's here experienced that raw fuel smell.
good to see you subscribed to that thread too.
it seems like a factory issue esp. combined w/ extreme heat climates. it comes and goes.
i experienced it a few times when i was on stock...but after some mods to the exhaust/intake/dp...no more smell.
i know it's tough to resist, but try not to push the car too hard when outside temps are +100 F; you'll avoid that smell.
a few of the x's here experienced that raw fuel smell.
good to see you subscribed to that thread too.
it seems like a factory issue esp. combined w/ extreme heat climates. it comes and goes.
i experienced it a few times when i was on stock...but after some mods to the exhaust/intake/dp...no more smell.
i know it's tough to resist, but try not to push the car too hard when outside temps are +100 F; you'll avoid that smell.
But at least no fumes in the car! I don't know if I wanna do that again though.
I guess I just have to mod it!
Lol I would have been out,but I'm nervous driving the car around before the show. Mobile detailers comin to the house tomorrow to wash,wax,and clay bar my car and it's goin back into the garage till the next day.lol. OH! And 100octane went from $5.99 to $6.80 in 3 F'in weeks! FML..Imma start pumpin 91 till it drops below 90 degrees again. Too hot to boost anyway.
Runs about $90. I'm not too sure of the work they do,but I'm confident since they do full polishing and high speed buffing. They say their detail packages go up to damn near $800!
I should be there.
I should be there.
Lol I would have been out,but I'm nervous driving the car around before the show. Mobile detailers comin to the house tomorrow to wash,wax,and clay bar my car and it's goin back into the garage till the next day.lol. OH! And 100octane went from $5.99 to $6.80 in 3 F'in weeks! FML..Imma start pumpin 91 till it drops below 90 degrees again. Too hot to boost anyway.
Bring it in and let's tune it for E85. Power of Q16 for 3.18 a gallon.
Also, if anyone needs wet sand and buff restoration on their cars, we do that as well.
We also just purchased a chassis shop, so we have chassis fabricators and full cage, tube chassis, etc.....fabrication capabilities in house in 30 days.
