darkmitsu

iTrader: (1)

Ok I am running the tephramod V7 96531706 with speed density on a 96 eclipse spyder 4g64 , this engine does not have a knock sensor and I need to disable p0325 knock sensor 1 circuit cel , how do I turn off the cel , when I was running the 94170015 I would run the 0x5650 code in the periphry 0 table , the periphry 0 table looks like this now?
(5650-no rear O2, No immobilizer, No knock)
(table name="ECU Periphery0 Hex" category="Periphery" address="faa" type="1D" level="2" scaling="Hex16") .

todd6027

iTrader: (10)

set bit 7 to 0 for knock sensor

for rear o2 bit 1 to 0
immo bit 3 to 0

then its same as 5650

darkmitsu

iTrader: (1)

I made the change to bit 7 and so far so good , thank you...