does anyone know what size the fitting is on the block that is located above the oil pressure sending unit I want to use this for my temp sending unit for my gauge
thanks

 

it's too small and it's the wrong thread size for your temp sender (1/8" npt won't fit there)

-joe

 

ok so where is everyone putting thier temp sending unit ?

 

bump

 

If youre talking about oil temp. I have a gauge that senses the temp of the oil in the pan by using the drain plug as a sensor and routing it through your firewall...

if thats not what ur talking about then nevermind..

 

the oil drain plug will work, but it's the coldest part of the oil stream..

-joe

 

no ive got that hooked up Im talking about the water temp gauge what is everyone else is using for thier sending unit and where r u guys hookoing it up pics of your setup would be nice
thanks

 

bump>?