My 04 RA did not come with keyless entry remotes. I think that the PO lost them, but is it possible that my car does not have a keyless entry system? Assuming they were just lost, what is the P/N, and can I buy them online and program them myself? Thanks.

 

the guy at the dealership that sold me my 04 RA told me it didnt come with one but he threw in and programed 3 for me for no cost

 

They are lying if they said it doesn't come with them. Getting keyless entry wasnt an option on the car. Even in the brochure it said it was a standard thing.

 

They are EASY to program. Just buy a couple off of eBay and then program them. Follow the instructions below. BTW, I used a paper clip to jump pins 1 & 4.

http://ebiz.netopia.com/pyr/mit490/

 

When I got mine from the dealership(used) they said they only had one set and we didnt know if the previous owner might have kept them and maybe have stole the car later or something like that but then a couple weeks later we got a call saying they found the extra set and I was perty happy

 

Anyone know what P/N, FCC #, etc. to look for on ebay?

 

is the keyless entry a stadard thing?, i have an 05 ralliart and bought it used from carsense and it didnt come with one.

 

yea its standard

 

the back of mine says OMRON g8d-525m-a if thats what your looking for

 

oh yea i talked to them and they said it was but i had to go to a dealership to get it and they would pay for it.

 

i know this thread is kinda old but i lost my car keys yesterday night along with the only remote. has anyone programmed one themselves lately? my brother got one for his 4Runner a while ago off ebay and couldnt get it to work. i'm about to buy one too but the directions above are kinda confusing. can anyone break it down in simple terms? thanks

 

Seems pretty simple to me. You connect pin 1 to pin 4 in the data port (under the dash by your right knee), put the key in the ignition, then press the hazard switch 6 times within 10 seconds. The doors should lock and unlock to tell you that the keyless system is ready to be programmed. Press the lock button on any remotes you want to program three times, and the doors should lock and unlock to tell you it worked. Once you've done all the remotes, remove the key and the wire connecting pins 1 & 4 in the data port, and you're done.

 

I did it just a couple of months ago, pretty easy actually. If you screw up or run out of time, just start over. You really can't screw anything up. Again, just use a paperclip to jump the two pins.

 

of course our cars come with it, we arnt in 94 no mo'