*UPDATE*
The make a gasket has failed. Its leaking on the underside again. Right when i have to do the most driving Only thing i can think of now is to double gasket it an possibly get that extra from Bruce to try an tig.

 

have you tries filling it with JB weld? Though that not as good as welding its pretty strong

 

Yea i tried that before i put on the make a gasket.
It worked horribly. It was shooting brake fluid as soon as i installed it. I was able to chip off the JB with my fingernail.

 

yeah to get any epoxy to hold you would need to get the thing cleaned, aircraft type clean.

 

Guess its just time for you to send it to me im only 800miles away in Naples FL lol ill even pay one day shipping back for you

 

Well i yanked out the part (again) and on the bottom side of the service plate the gasket had literally blown out. The gasket had literally torn in half at the bottom and was sticking out of the plate. This time i did something a little different. Instead of cutting the make a gasket in a circle in the middle i just put a solid square with the bolt holes punched out. That way the gasket itself is structurally stronger and wont blow out so easily under pressure.
I can literally swap this part out in 20 min now lol

 

What's the total mileage on your Ralliart?

 

Prob around 120k