Sorry to say, but it feels good knowing I'm not the only one getting pieces that don't fit right. I bought three sets at once (9 individual parts in all), and with how much variation there was I never placed an order for the rest of the stuff I wanted. I did buy a hood scoop though from someone on here as a part out (I could see the pics that it fit).
As for the spats, one fit dead one, the other was kinda wonky but not too bad. I was able to heat it with a blow dryer, and make it fit a bit better. But one of the oddest variances was the window pillars. The smaller "C" pillar is the same length on both sides, but the pieces from REXPEED were cut so that one was a half inch shorter than the other?!? To me that says someone doesn't care enough about their product to even look it over before sending it out. I mean how hard is it to hold them up and see if they are the same (mirror images of eachother)??

Okay guys let's get BACK ON TOPIC please. As you can see on the fog deletes fitment is dead on. The lip will be the same still have a lot of shaping to do. When weather permits will get right back on it.

Everyone needs to keep in mind, that all of there parts are hand made. They are not stamped out or injected. Don't get me wrong, if something doesnt fit then it needs to be replaced. The fitment of the spats would most likely be my fault. I designed them and test fit them. Both times they fit. The current lip will be test fit on however many RAs that I can.

Guinea Pig #36 reporting for duty. We can just leave it on mine once we make sure it's all good right? I mean you'd have a mould made for it and we'd just be fitting the actual piece right?

Sorry, your right, didn't mean to stray
Back on track....

Got u on the list. How far u live from bloomingdale. I've been working out there for the last 2 mo.

15-20 mins, at most

If I swung by the dealer, would they let me try it on a few RAs including the SB. I'll protect the finishes. I'm still a couple weeks from that point.

That's a good idea Gc try it on as many as you can find.

If we had any on the lot, I'm sure we could work something out, but we haven't been able to keep one for more than 2-3 days. As soon as they hit the lot they sell and many are pre-ordered

I'm confused on who is making what. Am I correct in thinking that there are two different lips being designed right now, by two different people, and both being test fit on blue RA's?

This is why I am confused...

Yes you are correct. My lip is being produced by JDP engineering.


gccruz is producing the lip himself and then Rexspeed will complete it.

what he said

put down some body filler on the middle section


By null at 2011-05-29

By null at 2011-05-29

By null at 2011-05-29

By null at 2011-05-29

I want those ducts NOW. been waiting forever for them!

like if I could pay you to make a set for me right now, I'd do it

can't stand the look of factory fogs. look like dimples