I'm trying to find alternatives to the standard sensors AEM sells for outrageous prices to use with my EMS...

Which sensors can we use and what do we need to use to adapt them to work with the AEM? I was hoping I could use just a normal GM 3bar MAP sensor instead of the AEM's 3.5bar MAP sensor. If so, which part#('s)?

Any and all info would be helpful on this topic... thanks. =]

 

*bump*

also, any vendors on here sell cheap MAP and IAT sensors for the AEM?

 

You can use a GM MAP sensor cause that's what I have. Don't know the part#. Works like a charm

 

If you download the free AEM EMS software from the AEMPower.com website and go in the Setup -> Sensors menu and open up the wizard for each sensor, you'll get a list of all the supported sensors. AEM supports several GM MAP sensors by part number for instance. This way you can see all of them.

You can, of course, use any sensor you like if it's 0-5V and you have the calibration data, but using one from the Wizard makes things a lot easier.

-Mike

 

is the GM 5-bar going to be a bltch to tune with?

 

Is there some where locally they carry the GM AIT sensor?

 

Yes, your GM Parts dealer.

 

Where are you located? I can have them shipped to you tommorow if you like.

 

You should be able to technically use any sensor as long as it is 0-5v. You just would need to manually calibrate it.

 

what is the difference between a 3.5 and a 5 bar map sensor?

 

the 5 bar map hold more boost alot more boost