Yep it was on that page, it raining here (just for a change in Melb) when it stops i shall be out fitting it.

 

No good fellas, hooked it all up, the pluse wire to the tacho output and the tacho earth to batter neg. Started her up, tacho worked, but the speedo said i was going 100k, the speedo moved with the revs. Tried swaping the wires over, tacho didn't work then. Any ideas?

 

swap the 2 wires around.. obviously youve gotta electronics speedo, and somethings aorund the wrong way..

the CC is a cable activated speedo cluster, so i didnt have any of these hassles

 

Tried that, tacho didn't work then

 

I cant see where the problem lies...are you sure you conected the correct wires?

 

Tach earth to the negative on battery
pluse to the tacho output on the firewall.
Is this right?

 

This might seem stupid, but do both wires conect to the rev counter, as i have it now earth went to the rev counter and the pulse went to the speedo area,