Ok i have Evoscan and ECUflash for my tuning programs i also have mitsulogger as a backup. I have the Zeitronix wideband sensor i can also use that to log also. My problem is that my wideband sensor hooks up to the PC using a com port or serial port however you would like it to be stated but my computer does not have a com port i just bought the PC to tune and now i cant any suggestions like can i hook it up in another fashion like com to USB port thank you and i hope i am posting in the right forum area thanks in advance.

 

Radio shack and computer stores sell a Serial to usb converter. I run my Lc-1 with a converter.

 

Once your wideband is connected to your laptop with the converter. Open the device manager to see what com port the wideband is on.

 

sorry bringing up a dead thread but bought the converter and then plugged it in installed driver and it says com port one but evo scan will not recognize it plz help

 

did you set evoscan to use com1 for wideband? which wideband and serial-to-usb converter that you're using?