Does anyone know the addresses for the following 94170008 ROM tables?

Thanks

<table name="Boost Enhancement Enrich/Enlean (Anti-lag) Map" category="Fuel" type="3D" level="1" swapxy="true" scaling="AFR">
<table name="Load" type="X Axis" elements="19" scaling="Load"/>
<table name="RPM" type="Y Axis" elements="20" scaling="RPM"/>
</table>


<table name="Boost Enhancement Adv/Ret Map 1 (Anti-lag)" category="Timing" type="3D" level="1" swapxy="true" scaling="Timing">
<table name="Load" type="X Axis" elements="19" scaling="Load"/>
<table name="RPM" type="Y Axis" elements="20" scaling="RPM"/>
</table>

<table name="Boost Enhancement Adv/Ret Map 2 (Anti-lag)" category="Timing" type="3D" level="1" swapxy="true" scaling="Timing">
<table name="Load" type="X Axis" elements="19" scaling="Load"/>
<table name="RPM" type="Y Axis" elements="20" scaling="RPM"/>
</table>

 

If these tables are active in our ECU(which I belive they are, 3e6d looks like the "vacuum advance" cruise mode map) then when we rescale the map the values get shifted. I believe is what was causing partial throttle knock. Once I carved out the ovelapping zones I got rid of it.

What I don't get is why the enrich/enlean map uses a timing map format for AFR.

 

From the disassembly I have done, I think this map is incorrectly identified as an AFR adjustment, it is a table referred to in the ignition sub routine, so it makes sense that it has the ignition Load and RPM axis.

MB

 

Ive looked at the 3d values in hex8, uint8, load8, & AirFlow8 but they mean nothing to me...idk.

 

Edit. Mispost

 

Jorge T or anyone.

Do you have the x and y addresses for the above?

Thanks!

 

use the same addresses found in the timing maps

 

Thanks.