What is the key to getting WB AFR to match the map AFR?
#16
Evolved Member
iTrader: (8)
I found I had to reduce the numbers in my table to get everything to match up.
I did everything in uint8 numbers and my actual values at the low frequency range was like 100 where factory was ~115. The numbers came out pretty rough and bounced around alot, but so do the factory values so who knows.
I did everything in uint8 numbers and my actual values at the low frequency range was like 100 where factory was ~115. The numbers came out pretty rough and bounced around alot, but so do the factory values so who knows.
#17
Evolved Member
Thread Starter
iTrader: (22)
Join Date: Nov 2003
Location: Northern KY near Cincy
Posts: 2,408
Likes: 0
Received 6 Likes
on
6 Posts
cool beans...something new to play with.
Any luck with this and tuning idle? I still get the occasional Hz spike at idle. Maybe this can smooth it a bit?
Any luck with this and tuning idle? I still get the occasional Hz spike at idle. Maybe this can smooth it a bit?
Thread
Thread Starter
Forum
Replies
Last Post
ddlopresti
ECU Flash
3
Mar 25, 2017 08:27 PM