Help ID ECU Hex file + definition to use
Thread Starter
Newbie
Joined: Aug 2008
Posts: 2
Likes: 0
From: t.o.
Help ID ECU Hex file + definition to use
Hey folks, trying to help out a friend with an 08 Lancer non-turbo 4b11 (I believe) He gave me a hex file and I haven't been able to figure out how to open it in ECUFlash.
Sorry if this is a newb q that has been covered but I've searched high & low (maybe not well enough). If it's already been answered please point me with a keyword to search! I haven't been able to find a definition file for it so I opened it with an EVO X definition.
Attached is a screen grab that you've seen before, which I'm assuming means I don't have the right definition file.
Thanks for any help.
/edit: crap, just realised I should have put this in the sticky for ECUFlash questions...sorry, couldn't delete it!
Sorry if this is a newb q that has been covered but I've searched high & low (maybe not well enough). If it's already been answered please point me with a keyword to search! I haven't been able to find a definition file for it so I opened it with an EVO X definition.
Attached is a screen grab that you've seen before, which I'm assuming means I don't have the right definition file.
Thanks for any help.
/edit: crap, just realised I should have put this in the sticky for ECUFlash questions...sorry, couldn't delete it!
Last edited by tashko; Aug 18, 2010 at 08:01 PM.
Thread Starter
Newbie
Joined: Aug 2008
Posts: 2
Likes: 0
From: t.o.
Well, I've managed to get some parameters by using an 52700007 definition (2008 ASDM Lancer GT X) which also calls the evo10base definition.
The addresses seem to be wrong in some places but I guess it's a start.
The addresses seem to be wrong in some places but I guess it's a start.
Thread
Thread Starter
Forum
Replies
Last Post
senate6268
Lancer Engine Management / Tuning Forums
343
May 22, 2026 07:27 PM
