Just wanting to know, is it possible to run a 3bar map sensor on an jdm evo7 ecu.
and secondly with the 3bar map sensor installed you can remove the maf sensor, or am i way out? lol

 

yes and (with the correct rom + IAT sensor for SD) yes.
I use a Omni 4 Bar though.

 

what sd rom you using ??

 

I'm not using one but i saw a SD tephra 5.10 on geekmapped.

 

The SD 90550001 is the one for the VII.

 

hi Gray any chance you would send it on to me

 

You might wanna throw some donations at Tephra for a V7 version. I did see him post somewhere concerning SD on V7 for 90550001

 

v7 or 90550701 doesnt have sd

 

I know but Tephra seemed to be working on it for someone.

https://www.evolutionm.net/forums/ec...550001-sd.html

 

Bringing this up from the dead.
Where on a JDM Evo 7 ECU does the MAP sensor wiring go?
Obviously it's power, ground, signal..

I'll be imstalling a GM 3 Bar MAP sensor into my GSR Lancer which is running an Evo 7 ECU. But all the ECU pinouts I find have no listing for a MAP sensor..

 

can you please share it with me!? My geek mapped account is not working ( plz