am I logging wrong timing ?
am I logging wrong timing ?
my logged timing doesn't match what's in the map. on lower loads there's minimum 1 degree difference and on peak loads I see logged timing 2-3 degrees lower compared to map timing. thought it was some interpolation issue, so put a block of 3's at peak load, got 1* in log. put 0's, got -2* etc.
timing trim vs air temp is zeroed out except first and last cells. in evoscan I've touched nothing, just installed it and ticked 'timing adv.' in eval it says x-20, request ID says 06. using rom 96530706 v7. any help is appretiated
timing trim vs air temp is zeroed out except first and last cells. in evoscan I've touched nothing, just installed it and ticked 'timing adv.' in eval it says x-20, request ID says 06. using rom 96530706 v7. any help is appretiated
Log "timing map ".
Look for a periphery bit that pulls timing too. Weird unknown timing pull at cruise which I found ends up more than just cruise. Also verify if your rom bases timing from uncompensated or compensated load
Look for a periphery bit that pulls timing too. Weird unknown timing pull at cruise which I found ends up more than just cruise. Also verify if your rom bases timing from uncompensated or compensated load
211ratsbut
I have that wierd bit disabled
Aaron, knock was max 2 counts, that won't pull whole 2* timing I think
as about intake temps, as I've posted in op, timing trim vs air temp is zeroed out except first and last cells. and there isn't such low or high temps outside to touch that thresholds
I have that wierd bit disabled
Aaron, knock was max 2 counts, that won't pull whole 2* timing I think
as about intake temps, as I've posted in op, timing trim vs air temp is zeroed out except first and last cells. and there isn't such low or high temps outside to touch that thresholds
Does your 2byte-to-1byte multiplier in the rom match evo's and formula? EGR advance at cruise will add timing above the timing map if you see an advanced timing variance in that area.
-Jamie
-Jamie
Last edited by Dynotech Tuning; Dec 24, 2012 at 11:20 PM.
Trending Topics
no, haven't got the chance to log yet mate
and what will I get from logging it ?
p.s. just opened evoscan and there's no such item named 'timing map' in the list o_o
(2.7 version)
and what will I get from logging it ?
p.s. just opened evoscan and there's no such item named 'timing map' in the list o_o
(2.7 version)
Last edited by stunt2; Dec 25, 2012 at 10:13 AM.
try mut33 and same formula as timing adv.
Look to see if your timing map matches your timing adv. If so then there is an error some where else. If the timing map matches where your load and rpm represent then you have something that is modifying timing advance.
Look to see if your timing map matches your timing adv. If so then there is an error some where else. If the timing map matches where your load and rpm represent then you have something that is modifying timing advance.
Last edited by 211Ratsbud; Dec 25, 2012 at 10:41 AM.
Thread
Thread Starter
Forum
Replies
Last Post
