Hey guys I'm wondering if anyone can give me a hand in getting the taxi to pass inspection, I just need my tune updated for the car to idle that's all. Don't need it drive or anything, literally just need to start and idle to pass the plug in.

I've been using an old tune but with all the changes I don't think the car will run anymore as I changed MAP sensors again. I can send you my tune that I've been using and can go from there. The old tune was also on a SD tune if that matters as ill need to keep using that anyway.

The car has an Omni 7 bar MAP sensor on it.

Stm 2.0
stm 650 cams
stm triple pumper w/ ASNU pumps
fic 2150s
omni 7 bar MAP

any help is greatly appreciated!!

 

Thread backfire!! Lol

 

Post your rom

 

Thank you. I'll get it up hopefully later today if not tomorrow

 

its now up in my orig post

 

I can certainly help you in person I have evo scan and tactrix. I've done it for another yellow VIII in cuse area.

I had a vipec in my old evo and self tuned the stock ecu over years before that

 

I have everything to flash the car myself. I just need it tweaked more or less for the map sensor so the car will start and idle

 

Thats where I got the scalings. Id like to help you sort the idle out if you had some time. I only changed the MAP VE scaling. no other things. Give it a shot. LMK, I would suggest setting BISS (if you have it) or adjusting the throttle blade on aftermarket TB, then clocking the sensor back below the suggested % to keep idle stability control active. Thats how I did it with the FB 70mm tb.

https://www.evolutionm.net/forums/ec...-scalings.html