mr.k

Hopefully some of you Evoscan guru's can help me out.

I'm running into an issue with evoscan not reading the ecu correctly. When I go to start a log, all of the variable values are zero or "x" in each function, is being read as zero. I have done multiple fresh installs of Evoscan and the drivers, yet nothing seems to help. I am not sure if this is a compatibility issue or what. I am no expert by any means with evoscan, so please guide me in the right direction if I am out of place.

Attached pic shows exactly how evoscan looks when I try to log:


The tactrix cable is new and fine; it can pull the rom in ecu flash with no problems.
My computer:
Windows 10 64 bit
Two generic USB hubs
One AMD USB 3.0 hub

Still get the same issue no matter what port is used.

Thanks in advance

mr.k

BUMP

I wanna get some logging done

mr.k

Bump.. Nobody knows how to fix this?

4b11slayer

Has to be some sort of scaling issues. Look how coolant temp is 300+ degrees.

mr.k

Not sure what is up with the coolant temp but everything else reads 0 for x. All the equations values represent 0 being the input.
Any help is appreciated though!

4b11slayer

what cable is it? your hooked up to both plugs?

mr.k

Tactrix 1.3u cable. This is a relatively new cable.
Both are plugs plugged in, ecu flash works fine, I can trigger any actuator in evoscan... Just no logging

Klaiceps

iTrader: (18)

I'm not near my laptop to see Evoscan but maybe try selecting a different ECU in the drop down list.