Exactly what the title says... Ive got a IX MR SE getting a few parts put on. Heres the list

Stock Turbo
3" TBE with high flow cat
ETS 4" wide intercooler
Injen intake kit with hard UIC & LIC
Cosworth 272 Cams
Tial BOV
Tial 38mm Waste Gate
Manual Boost controller tuned to 25psi
ARP Head Studs
walbro fuel pump
Exedy twin ceramic clutch
Stock ECU Tuned by the best


What are the guesses for HP and 1/4???

 

we have the same mods the only difference is I have meth at 30 psi. so I am guessing about 335 -340 hp. 12.30 in the 1320

 

that low??? ive got right now the TBE boost controler tuned at 25psi and an ARC box... and was 311hp on a dynojet.

 

I would say at around 359 whp and 342 lb/tq.

 

by the best huh?.. so your running a tial wastegate with a stock turbo?

 

350, 12.0

 

348awhp and 342ft./lbs torque. what do we get if we guess correct? and i too was wondering why would you put an extenal wastegate on a stock turbo? it sounds like a lot of unecessary work and trouble and i don't see what you would get out of it. and a 12.5 quarter time.

 

yeah that was ordered out of stupidity... i was planning on going fp green but ran out of funds...

 

dont get a green, go red bro. i believe the fp turbos have integral wastegates also. you could sell the tial, or save it for incase you go an extreme turbo route later

 

well i was in a toss up for 3 different turbos... HTA35r... ETS 6262 ... or the fp green..


you say red... lol the thread on this dispute of which was better was... well u know if u read it

 

330hp is the max my opinion with that set-up.

 

what size injectors do you have to go along with all of that stuff?
and what fuel are you using?

 

everything is stock unless listed above...

 

well in that case i guess

335.89377 whp and 340.4746 wtq

 

All these mods are great but where is

02 housing?
Headers/ Exhaust Manifold?
Downpipe?

I'd say a unsafe 340-350whp. And u don't need 25psi to push that, thats unsafe u just need about 22-23psi for your mods.