To start a new thread in this forum, a Dyno or DLL graph sheet must be posted within. Please do not start a new thread if you don't have a graph, or it will be removed.

In addition, any technical data and comments are welcome in the thread.

Please DO NOT vendor or dyno bash. We've all heard enough of "this dyno reads too high" or too low. A dyno or DLL graph is a tuning tool, and not meant to be measured against a different type of tool. Its only to be compared against itself.

If you are not posting a graph, do not use this forum! We have an Engine Management and Tuning forum located one slot below this.


Thanks.

 

Any VDR graphs should also include the VDR mode being used.

 

If you'd like to post a video in place of a graph, you may **if** the graph is from a shop that is an EvoM vendor. Vidoes that are blatant advertisements for non-vendor shops will be removed.

 

Bump (even though its a sticky)! Read these rules and follow them, I'm going to start deleting threads rather than moving them.

 

Bump for reminder; everything else WILL be trashed.