To start a new thread in this forum, a Dyno or VD graph sheet must be posted within. Please do not start a new thread if you don't have a graph, or it will be removed.

In addition, any technical data and comments are welcome in the thread.

Please DO NOT vendor or dyno bash. We've all heard enough of "this dyno reads too high" or too low. A dyno or DLL graph is a tuning tool, and not meant to be measured against a different type of tool. Its only to be compared against itself.

If you are not posting a graph, do not use this forum! We have an Engine Management and Tuning forum located one slot below this.


Thanks.

 

As an addendum, since some people are missing it,

**No Ralliart dyno graphs in the Evo section**

 

I have had some questions on this: A video that contains the graph in the original post is OK to count for the graph.

That said, videos that are shameless promotions of non-vendor shops will be removed.

Thanks for your attention to this matter.